Surface Drives

HEAT RESISTANT CLUTCH COVER FITS ALL PRO R MODELS ONLY. 23PROR, 35PROR AND 40PROR If in doubt as to which model you have please email us a photo, [email protected]

Oil seal and bearing kit for rebuilding surface drive tails on models PRO R ONLY fits Pro R surface drives Please email us a photo of your kit for assistance

Oil seal and bearing kit for rebuilding surface drive tails on models YM13S, YM22 and YM22B   Will not fit Feather Lite, Pro R or S models (or SD's from earlier than 2021)   Please email us a photo of your kit for assistance

Angle lock pin - Fits all models  

5/7hp FEATHER LITE SURFACE DRIVE REPLACMENT SPROCKETS: 1 PC - UPPER SPROCKET 1 PC - LOWER SPROCKET 1  PC 5/7hp FEATHER LITE SURFACE DRIVE BELT

Fits both versions of the Feather Lite Surface Drive, 7 hp and 13/16 hp   Gasket goes between the surface drive tail shaft, and the main housing

13/16 hp Feather Lite Replacement Clutch, upper sprocket, lower sprocket and belt

Performance Propeller - Stainless Steel - 12.75" x 10 Pitch 3/4" HEX HUB - For surface drives with 3/4" hexagonal prop shafts only

Performance Propeller - Stainless Steel - 12.4" x 10 Pitch 3/4" HEX HUB - For surface drives with 3/4" hexagonal prop shafts only

Fits various models, 13 SPORT and 18-22 PRO (has electric clutch)

Replacement switch for all Pro R models - FNR SWITCH (Forward, neutral & reverse)

Replacement switch for all Pro R models - Power Trim 

This kit retrofits your 13-16hp Feather Lite surface drive (YM13L) from centrifugal clutch to electric clutch. Kit compromises: 1" ID electric clutch Clutch harness and fuses Circuit breaker Bearings/Spacers Clutch cover housing Clutch on/off switch and...

Complete stainless steel fastener pack for rebuilding/refreshing your 4-7hp Feather Lite surface drive  Sold only as full kit

Complete stainless steel fastener pack for rebuilding/refreshing your 13-16hp Feather Lite surface drive  Sold only as full kit